Conveyor belt in use will have friction with roller, conveyor, material mouth and so on. The greater the friction force, the greater the damage to the conveyor belt. In order to reduce the wear of the conveyor belt, it is necessary to understand the main friction parts of the conveyor belt. The following Hengda conveyor belt introduces the main friction parts of the conveyor belt.
1、Friction between frame and conveyor belt, conveyor belt will sometimes run away due to the defects caused by the manufacture, installation and use of conveyor. When running too far, the contact between conveyor belt and idler bracket, frame will cause rubber wear and even make conveyor belt flanging.
2、The friction between the baffle of the guide groove and the conveyor belt, the wear of the baffle on the conveyor belt is a special kind of wear, such as improving the design method of the baffle and paying attention to maintenance, this kind of wear can be almost prevented.
3、Friction between idler and conveyor belt, the lower cover glue of conveyor belt is also subject to the friction of aligning idler and forward inclined trough idler. Wear occurs in the transition section from trough idler to drum and the conveyor bending protrusion.
4、The friction between the sweeper and the conveyor belt, the wear and tear caused by the sweeper to the conveyor belt is usually uniform, but when using the harder steel plate as the sweeper board, if the use method is not appropriate, the rubber besides dirt will also be cut down. When the foreign matter between the sweeper tip and the conveyor belt enters, deep scars will be scratched on the full length of the conveyor belt.
Above are the parts where the conveyor belt often wears in use. In installation and use, it is necessary to minimize the friction of these parts and prolong the service life of the conveyor belt.